Mossberg 935 Magnu Manuel d'utilisateur télécharger pdf (Page 21)

Windage may be adjusted by loosening the larger of the two screws and sliding

the sight leaf left or right in the sight base. Tighten the screw after adjustment

(Figure 16).

Remember: Move the rear sight in the same direction you would like the shot to

move. For example, if the point of impact is low and left of the point of aim, move

the rear sight up and to the right.

Figure 16

B. Turkey-Taker

Fiber Optic sights (turkey models only):

Elevation may be adjusted by turning the screw, located on the rear sight, in or

out. Turning the screw in (clockwise), will shift the point of impact up (Figure 17).

Windage may be adjusted by pulling up on the rear sight tab and swinging the rear

sight to the left or right, locking in place in one of the three slots (Figure 17).

Figure 17

C. Ghost Ring

Rear and M16 Style Front Sights (SPX Models)

Elevation may be adjusted by turning the elevation screw, located on the rear

sight, in or out. Turning the screw out (counterclockwise) will shift the point of

impact up. The sight is also marked to show the “up” direction. Turning the screw

in (clockwise) will shift the point of impact down.

Elevation may also be adjusted by turning the elevation screw, located on the

front sight, in or out. Turning the screw out (counterclockwise) will shift the point

of impact up. Turning the screw in (clockwise) will shift the point of impact down.

Windage may be adjusted by turning the windage screw, located on the rear sight,

in or out. Turning the screw in (clockwise) will shift the point of impact to the right.

The sight is also marked to show the “right” direction. Turning the screw out

(counterclockwise) will shift the point of impact to the left.

122276 1/19/12 2:37 PM Page 19

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Pas de commentaire

Mossberg 935 Magnu Manuel d'utilisateur Page 21